Acopia Networks 810-0044-00 Installationshandbuch PDF herunterladen (Seite 160)

100

101

Adding a Direct Volume

Setting CIFS Options

8-4 CLI Storage-Management Guide

You can set this any time, even after the volume is enabled.

For example, this command sequence makes the ‘access~/G’ volume count the free

space in all back-end shares, even multiple shares that draw from the same back-end

storage:

prtlndA1k(gbl)# namespace access

prtlndA1k(gbl-ns[access])# volume /G

prtlndA1k(gbl-ns-vol[access~/G])# freespace calculation manual

prtlndA1k(gbl-ns-vol[access~/G])# ...

Using Automatic Free-Space Calculation

By default, free space is calculated based on the IDs of the volumes behind the

back-end shares. If any of these shares report the same volume ID, their free space is

counted only once. To return to this default, use

no freespace calculation manual:

no freespace calculation manual

For example:

bstnA6k(gbl)# namespace medco

bstnA6k(gbl-ns[medco])# volume /vol

bstnA6k(gbl-ns-vol[medco~/vol])# no freespace calculation manual

bstnA6k(gbl-ns-vol[medco~/vol])# ...

Setting CIFS Options

The next step in configuring a volume is addressing its CIFS options, if necessary:

This section does not apply to volumes in NFS-only namespaces; skip to the next

section if this namespace does not support CIFS.

There are five CIFS-volume attributes that back-end filers may or may not support.

They are named streams, compressed files, persistent ACLs, Unicode file names on

disk, and sparse files. Each volume can support any and all of these capabilities.

However, all filer shares used in a volume must support the capabilities advertised in

the volume. For example: if your volume is going to support compressed files, then

all of its back-end filer shares must also support compressed files.

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 491 492

Kommentare zu diesen Handbüchern

Keine Kommentare

Acopia Networks 810-0044-00 Installationshandbuch Seite 160

Kommentare zu diesen Handbüchern